Westerbeke 120D-TWO Bedienungsanleitung PDF herunterladen (Seite 40)

Component Removal and Replacement

R300 - Y-Axis Belts

Table of Contents

Take note of the current tension of the Y-Axis Belt by using your

thumb and index finger. You will need to try and match the

current tension of the old belt to the new Y-Axis Belt that will be

installed.

1. Power OFF and unplug the PLS.

2. Remove the X-Axis Arm.

3. On both Y-Axis Rails is a Y-Axis Belt

Clamp. Unscrew all 6 screws, 3 on

each, and set the screws and clamp

aside.

4. After the Y-Axis Belt Clamp has been

removed staple the new Y-Axis Belt

(1) to the old belt (2). Do not overlap

the belt and make sure that the teeth

are in the same direction.

5. Slowly pull the other end of the old belt, allowing the new belt to be pulled through

the inside of the Y-Axis Rail. Make sure that you do not twist the belt going through

the rail. The teeth of the belt should be facing inward.

6. Once the new belt is completely through the Y-Axis Rail, remove the staple and

discard the old belt.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Keine Kommentare

Westerbeke 120D-TWO Bedienungsanleitung Seite 40