Westerbeke 120D-TWO Bedienungsanleitung PDF herunterladen (Seite 31)

Component Removal and Replacement

R210 - X-axis Belt

Table of Contents

1. Power OFF and unplug the PLS.

2. Remove #2 mirror cover by removing

the thumbscrew and sliding the cover

to the right and up.

3. Remove the two screws (upper and

lower) that attach the Belt Clamp to

the Focus Carriage. Slide the Focus

Carriage off to the left.

4. Loosen the three screws (3) (1/2 turn)

that mount the tensioning bracket (2).

Also, back off the setscrew (1) until

the tip does not make contact (this

will partially release the tension on

the belt) but do not remove the screw

completely.

5. Loosen, do not remove, the 2 screws

that attach to the left of the bracket

that holds the ends of the belt

together. Slide the bracket off of the

end of the belt. DO NOT PULL THE

BELT OUT OF THE X-AXIS RAIL AT

THIS TIME. JUST LEAVE IT

HANGING. THE PURPOSE IS TO

RELEASE THE BELT TENSION

COMPLETELY.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Keine Kommentare

Westerbeke 120D-TWO Bedienungsanleitung Seite 31