Westerbeke 120D-TWO Bedienungsanleitung PDF herunterladen (Seite 37)

Component Removal and Replacement

*If you plan on replacing the motor do not install the new drive gear or retaining clap at this time.

7. Position the new gear or clamp on the

shaft so that it is approximately

centered on the shaft just like it was

when you took it off. There should be

a small gap between the retaining

clamp and the motor (3), no gap

between the retainer and the gear (2),

and the shaft should be slightly

protruding out of the gear similar to

the picture shown (1). Once the gear

and retainer are in place tighten the

screw.*

X-Axis Motor

8. Loosen the 4 mounting bracket

screws. Once you remove the

screws do not pull on the bracket as

it is still attached with a wire

connector.

9. Undue the connector by pressing the

connectors latch and gently pulling on

the connector.

10. Located on both sides of the heat

sinks are two Philip head screws.

Remove the four screws and set

them aside. Try not to get the Heat

Sink Compound on your hands or

clothes. Use more Heat Sink

Compound if necessary.

11. Re-install the Motor Module onto the X-Axis rail with the 2 screws that were removed

from steps 3 and 4. Make sure that the belt loops around the drive gear.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 71 72

Keine Kommentare

Westerbeke 120D-TWO Bedienungsanleitung Seite 37