Westerbeke 120D-TWO Bedienungsanleitung PDF herunterladen (Seite 32)

Component Removal and Replacement

6. Using a stapler, attach one end of the

old belt (2) to one end of the new belt

1). Do not overlap the belt and make

sure that the teeth are in the same

direction.

7. Slowly pull the other end of the old

belt, allowing the new belt to be

pulled through the inside of the X-axis

arm. Make sure that you do not twist

the belt going through the rail. The

teeth of the belt should be facing the

inside.

8. Once the new belt is completely through the X-axis rail, remove the staple and

discard the old belt.

9. Re-attach the belt clamp to the ends of the belt. Make sure that the rounded side

of the clamp faces inwards. Gently pull the belt through the clamp until the slack

in the belt is reduced. Leave the belt slightly loose because we will tension the

belt by adjusting the setscrew on the tensioner bracket on the left side of the X-

axis rail. Now, tighten down the screws on the clamp. DO NOT TRIM OFF THE

EXCESS BELT AT THIS TIME, WE WILL DO THAT LATER.

10. For the next step, you will need a spring scale and a ruler which the end of the ruler

is actually the "0" point. Some rulers "0" point is offset from the end so you would

not want to use that kind of ruler.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Keine Kommentare

Westerbeke 120D-TWO Bedienungsanleitung Seite 32