Westerbeke WPDS-20 Betreibershandbuch Seite 58

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 114
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 57
Servicing
After
Initial
50
Hours
of
Operation
1.
Change the engine's lubrication oil and oil filter.
2.
Replace the fuel filter element as described on page
35.
Clean and replace the filter element and bowl
of
the primary fuel filter/Water separator, if one has been installed.
*3. Torque the
cylinder head nuts.
*4. Adjust valve clearances.
5.
Adjust the alternator, water pump and compressor drive belt tension, if required.
6.
Lubricate the throttle, the
RUN
linkage cable, and the transmission's remote control cable.
7.
Clean the air intake screen.
8. Adjust the engine's idle as needed.
9.
Change the transmission's transmission fluid.
Servicing
After
Every 100
Hours
of
Operation
1.
Change the engine's lubrication oil and oil fnter.
2.
Adjust the alternator and water pump drive belt tension, if required.
3.
Check the transmission fluid
or
oil level.
Servicing
After
Every 250
Hours
of
Operation
1.
Replace the on·engine fuel filter element and service the primary fuel filter/water separator as needed.
Check the sea water pump's
impeller.
2.
Change the transmission's transmission fluid.
Servicing After Every 500
Hours
of
Operation
*1. Torque the cylinder head nuts.
*2. Adjust the valve clearances.
3.
Drain, flush, and refill the fresh water cooling system.
*4. Check the condition
of
the starter motor drive pinion; lubricate the pinion.
5.
Check the sea water
pump
for any internal wear. Check the pump's cover, cam, and impeller. Replace
those parts that are excessively worn.
Westerbeke Diesel
Engines
58
Seitenansicht 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 113 114

Kommentare zu diesen Handbüchern

Keine Kommentare