Westerbeke BCD 4.4KW Betreibershandbuch PDF herunterladen (Seite 69)

MAINTENANCE AND ADJUSTMENTS

Introduction

This section contains a scheduled preventive maintenance program and several adjustment procedures the

owner/operator can perform without the benefit

sophisticated and expensive tools and instruments.

Preventive

Maintenance

Perform the preventive maintenance

accordance with the schedules listed in the following paragraphs.

Adherence

these schedules will ensure the equipment is maintained in the best possible condition and

that it will perform

expectations. Those items marked

an asterisk

(*)

are recommended

be per-

formed

an authorized dealer

distributor.

Daily

(before

each

use)

Check the oil sump level. Maintain the oil level at

near upper level mark on dipstick.

Check the coolant level in the plastic recovery tank. Maintain this level at

above the level marked

ADD.

Visually inspect the unit; check for loose belts, chafed

broken wires, loose brackets and fittings,

damaged hoses, loose clamps, and other equipment not properly secured.

Check the fuel supply. Fill tank(s) with a good grade of

No.2

diesel fuel, if required.

Check the primary filter/water separator. Drain and service as required.

primaryfilter/water separator

is optional, but strongly recommended.)

Check the generator's gauges

lights

for

proper oil pressure, operating temperature, and starting bat-

tery charging voltage once the engine is operating.

Check the generator's output meters (when installed) for proper AC voltage and output frequency.

Monthly

Check the condition

the zinc anode in the heat exchanger's sea water circuit. Clean

replace the anode,

as required. Keep the area inside the heat exchanger clean of zinc anode debris.

Servicing

After

Initial

Hours

Operation

Change the engine's lubrication oil and oil filter.

Replace the fuel filter element in the electric fuel lift pump and in the engine-mounted secondary fuel fil-

ter. Change the fuel filter element and clean the optional filter/water sedimentor, if a separator has been

installed, and if the model type permits cleaning.

*3. Torque the cylinder head bolts.

Westerbeke Generators

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 93 94

Kommentare zu diesen Handbüchern

Keine Kommentare

Westerbeke BCD 4.4KW Betreibershandbuch Seite 69

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Westerbeke BCD 4.4KW