Westerbeke 4.5 KW BGC -60Hz Betreibershandbuch PDF herunterladen (Seite 27)

Exhaust Elbow Installation

The Westerbeke Corporation offers a 45°and

exhaust

elbow as well as

exhaust riser you can install on your

generator. Refer

the instructions below when installing

the exhaust elbow purchased for your generator.

Coat only one side of the exhaust gasket with ·"High

Tack"

adhesive sealant. Place this coated surface

against the exhaust manifold's exhaust port flange (the

gasket should stick

the flange without falling off).

2. Place the clamp over the elbow's flange. Place your ex-

haust elbow against the exhaust manifold's flange so

the exhaust manifold's flange rests snug against the

ex-

haust elbow's flange with the gasket centered between

the two. Now slip the exhaust clamp over both flanges.

Tighten the clamp just enough so the exhaust elbow

can remain attached

the manifold and still be

rotated.

The exhaust elbow discharge must be directed

downward

so the miXiure of sea water and exhaust

gases will flow/fall downward into the exhaust

muf-

fler which must be positioned below the exhaust

elbow. There should be no loops or rises in the

ex-

haust hose connected between the exhaust elbow

and the muffler, as these would trap water and

pos-

sibly allow water to flow back into the engine during

starting

at shut down.

Adjust the elbow

rotating it until the desired

aJign-

ment with the exhaust piping

acquired.

5. Carefully tighten the clamp between 2

3 Ib-ft,

35 Ib-in, or 0.27

0.41

kg-m.

CAUTION

Approach

the

II>-It

torque

limit

with

caution.

The

clamp's

threads

will break

than 3

lI>-

is applied

Ihe

clamp.

a leak exists, correct it immediately.

* Manufactured by Permatex Company, Brooklyn,

Weslerbeke Generators

45°

ELBOW

CLRMP

CLAMP

90·

ELBOW

EXHAUST

RISER

ClAMP

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 94 95

Kommentare zu diesen Handbüchern

Keine Kommentare

Westerbeke 4.5 KW BGC -60Hz Betreibershandbuch Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Westerbeke 4.5 KW BGC -60Hz