Westerbeke W-70GA Installationshandbuch Seite 30

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 64
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 29
DUAL
OUTPUT
ALTERNATORS
DESCRIPTION
Dual output and high output alternators are available as
optional equipment on most
WESTERBEKE engines. These
alternators can
be
installed during factory assembly or
as
add-on equipment at anytime.
Dual alternators
can
be configured to charge
two
banks
of
batteries at the
same
time or, using a battery selector switch,
charge each set
of
batteries separately.
TO
INSTALLATION
If
an optional dual alternator has already been factory installed,
simply follow the
WESTERBEKE
wiring diagram and the
engine installation instructions.
If
the new dual alternator is being added to an existing "in-
the-boat"
engine, carefully follow the alternator installation
instructions below:
1.
Disconnect the alternators negative cable from the
battery.
2. Remove the alternator and disconnect or tape
off
the
output [positive] cable. Do not reuse.
3. Install the new alternator.
4. Attach a new heavy gauge output cable[s] from the
alternator's output terminal [s]. Using the cable sizes
indicated.
LENGTH
REQUIRED
----
UP
TO.~6='
_#~4
WIRE
UP
TO
12'
#2
WIRE
UP
TO
20'
#0
WIRE
{ALWAYS
USE
FINE
STRAND
CABLE]
5. Make certain that the batteries negative post ground
cable to the engine block is the same heavy gauge as
the positive cable.
6. Mount the regulator to a flat surface in a cool dry
location.
a. Connect the black wire to the ground terminal on the
alternator.
TO
A
CAUTION:
Do
not
connect
any
power
source
with-
out
first
grounding
the
regulator.
b. Plug the 2-pin connector into the alternator, make
certain it is firmly seated.
c.
TIle red "battery sense" wire should
be
connected to
the batteries positive
[+]
post [or the positive cable].
d. The brown wire
"keyed ignition" is the key circuit
which actuates the regulator, this wire must connect
to a switched
[+]
12 volt source. Refer to the
WESTERBEKE WIRING DIAGRAM for the proper
connection.
Dual
Pulleys
A variety
of
accessory pulleys for high powered and dual
charging alternators are available from your
dealer.
BATTERY
1
Engines
& Generators
24
SPACER
TO
MOUNTING
BRACKET
DUAL
OUTPUT
ALTERNATOR
[CHARGING
ONE
BATTERY]
-------
"BATIERY
SENSE"
TO
BAmRY
POSITIVE
POST
~ONNECTS
TO
PINK
AND
.
BLUE
LEADS.
THE
PINK
CONNECTS
TO
THE
BUZZER.
THE
BLUE
WIRE
CONNECTS
TO
THE
OIL
PRESSURE
SWITCH.
DUAL
OUTPUT
ALTERNATOR
[CHARGING
TWO
BATTERIES]
Seitenansicht 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare