Westerbeke 4.5 KW BCGTE 60Hz Betreibershandbuch PDF herunterladen (Seite 21)

Exhaust Elbow Installation

The Westerbeke Corporation offers a 45'and 90'exhaust

elbow as

well as an exhaust riser you can install on your

generator. Refer

the instructions below when installing

the exhaust elbow purchased for your generator.

NOTE:

Fabricated exhaust elbows

risers at-

tached to the exhaust manifold shall not exceed S

Ibs

when unsupported.

Coat only one side of the exhaust gasket with '''High

Tack"

adhesive sealant. Place this coated surface

against the exhaust manifold's exhaust port flange (the

gasket should stick to the flange without falling off).

Place the clamp over the elbow's flange. Place your ex-

haust elbow against the exhaust manifold's flange so

the exhaust manifold's flange rests snug against the ex-

haust elbow's flange with the gasket centered between

the two. Now

slip the exhaust clamp over both flanges.

Tighten the clamp just enough so the exhaust elbow

can remain attached

the manifold and still be

rotated.

The exhaust elbow discharge

111.Ufl1

directed

downward so the mixture of

sea

water and exhaust

gases will flow/fall downward into the exhaust

muf-

fler which

111.Ufl1

be positioned below the exhaust

elbow. There should

no loops or rises

the ex-

haust hose connected between the exhaust elbow

and the muffler, as these would trap water and

pos-

sibly allow water

flow back into the engine during

starting or at shut down.

Adjust the elbow

rotating it until the desired align-

ment with the exhaust piping is acquired.

5. Carefully tighten the clamp between 2 to 3 Ib-It, or

to 35 Ib-in,

0.27

0.41

kg-m.

CAUTION

Approach the 3 Ib-It torque limit with caution. The

clamp's threads will break

if more than 3 Ib-It

ap-

plied to the clamp.

If a leak exists, correct it immediately.

* Manufactured by Permatex Company, Brooklyn,

N.Y.

Westerbeke Generators

GASKEI

CLAMP

45'

ELBOW

CLAMP

90'

ELBOW

EXHAUST RISER

CLAMP

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 84 85

Kommentare zu diesen Handbüchern

Keine Kommentare

Westerbeke 4.5 KW BCGTE 60Hz Betreibershandbuch Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motor Westerbeke 4.5 KW BCGTE 60Hz